1. Next, choose how OmniPass notifies you of various events. We recommend you
keep Taskbar Tips on Beginner
mode taskbar tips and Audio Tips on at least
Prompt with system beeps only until you get accustomed to how
OmniPass
operates. Click [Next] to proceed with user enrollment. You will then see a
Congratulations screen
indicating your completion of user enrollment.
2. Click [Done] to exit the OmniPass Enrollment Wizard. You will be asked if you’d
like to log in to OmniPass with
your newly enrolled user; click [Yes].
Enrolling a Fingerprint
Enrolling a fingerprint will increase the security of your system and streamline the
authentication procedure.
You enroll fingerprints in the OmniPass Control Center. With an OmniPass user
logged in, double-click the system tray OmniPass icon. Select the User Settings tab
and click Enrollment under the User Settings area. Click Enroll Authentication
Device and authenticate at the authentication prompt to start device enrollment.
1. During initial user enrollment, you will be prompted to select the finger you
wish to enroll. Fingers that have
already been enrolled will be marked by a
green check. The finger you select to enroll at this time will be marked
by a red
arrow. OmniPass will allow you re-enroll a finger. If you choose a finger that
has already been enrolled and continue enrollment, OmniPass will enroll the
fingerprint, overwriting the old fingerprint. Select a finger to enroll and click
[Next].
2. It is now time for OmniPass to capture your selected fingerprint. It may take a
several capture attempts before
OmniPass acquires your fingerprint. Should
OmniPass fail to acquire your fingerprint, or if the capture screen
times out,
click [Back] to restart the fingerprint enrollment process.
Your system has a “swipe” fingerprint sensor. A swipe sensor is small and
resembles a skinny elongated rectangle. To capture a fingerprint, gently swipe
or pull your fingertip over the sensor (starting at the second knuckle)
towards
yourself. Swiping too fast or too slow will result in a failed capture. The Choose
Finger screen has a [Practice] button; click it to practice capturing your
fingerprint. When you are comfortable with how your
fingerprint is captured,
proceed to enroll a finger.
Appendix 115
To Next Page
Loading...
