Utility tool: The Utility tool contains two options: Hard Disk Data Delete and
Partition Creation.
• The Hard Disk Data Delete utility is used to delete all data on the hard disk
and prevent the data from being
reused. NOTE: Do not use the Hard Disk
Data Delete utility unless you are absolutely certain that you want
to
erase your entire hard disk, including all partitions.
To delete hard disk data:
a. Click the [Hard Disk Data Delete] button
b. The progress bar appears, followed by the EULA screen.
c. Agree to the EULA and click [Next].
d. Choose the hard disk from which the data should be deleted in the list
of hard disks and click [Next].
• The Partition Creation utility is used to change the C: and D: drive partition
sizes. To run this utility:
a. Click the [Partition Creation] button.
b. A progress bar screen appears, followed by the EULA screen. Agree to
the EULA.
c. On the Recovery Tool - Partition Creation screen move the slider to
set disk size, then click [OK].
d. Click YES in the Partition Creation confirmation dialog.
Recovering your Factory Image using Recovery and Utility (for new hard drive or
non-bootable hard drive)
If you have installed a new hard drive or your hard drive is not bootable, perform the
following steps.
1. Power on your system. When the Fujitsu logo appears on the screen, press the
[Enter] key.
2. Highlight the CD/DVD option from the Boot Menu and press [Enter].
3. Insert the bootable disc in your DVD drive, then click [OK].
4. Select CD/DVD boot mode: UEFI Mode and press [Enter]. While the files are
being loaded from the disc, Fujitsu
logo screen will appear followed by a
progress bar screen at the bottom of the screen.
Appendix 144
To Next Page
Loading...
