Fujitsu M10 - Page 107

Table 3-9
Problems resolved in XCP 2230 (continued)
SPARC M10-
RTINo. 1 4 4S Description Worka rou nd
RTIF2-
140623-003
x x x Suppose that the XSCF STANDBY LED
on the operation panel blinks immediately
after turning on the input power (AC
ON). If the power switch on the
operation panel is pressed, powering
on/off the physical partition (PPAR)
becomes disabled.
The power to the PPAR is turned on/off
when:
- The power switch on the operation
panel is manipulated.
- The poweron(8) or poweroff(8)
command is
executed.
- PPAR power on/off operation is
performed on XSCF Web.
- Power supply interlocking by RCIL
takes place.
- The auto power control system (APCS)
issues a power on/off instruction.
To operate the power switch on the
operation panel immediately after
turning on the input power, wait at least
30 seconds
after the STANDBY LED
switches from blinking to being
constantly on.
RTIF2-
140731-001
xx xAn Event Log ("Host stopped") is not
displayed by a showlogs(8) event and
showmonitorlog(8) when the primary
domain is shutdown.
There is no effective workaround.
RTIF2-
140805-001
xIf the system board is deleted by the
dynamic reconfiguration of physical
partitions, a process on the logical
domains may produce a core dump by
SIGILL (Illegal Instruction).
There is no effective workaround.
Chapter 3 Information on Software 93