Fujitsu M10 Product Notes

Table 3-9
Problems resolved in XCP 2230 (continued)
SPARC M10-
RTINo. 1 4 4S Description Workaro und
RTIF2-
140808-001
xx xOn a SPARC M10 system to which an
uninterruptible power supply (UPS) is
connected, the following problem may
occur: After recovery from a power
failure occurring while Oracle Solaris is
inactive or the physical partition (PPAR)
is powered off, PPAR may erroneously
reboot even though the PPAR should
remain powered off.
Note - When a power failure occurs
while Oracle Solaris is active and a UPS is
connected, Oracle Solaris will automatically
reboot upon power recovery.
This phenomenon may occur when the
operation below is followed by a power
failure recurrence and then a recovery
therefrom.
- A power failure occurs while Oracle
Solaris is active. After Oracle Solaris
boots automatically upon power
recovery, the shutdown command is
executed on Oracle Solaris to
stop
Oracle Solaris (display the ok prompt).
[Example]
#
shutdown -y -g0 -i0
- A power failure occurs while Oracle
Solaris is active. After Oracle Solaris
boots automatically upon power
recovery, the shutdown command is
executed on Oracle Solaris to power off
the PPAR.
[Example]
#
shutdown -y -g0 -i5
If you want to
stop Oracle Solaris, there
is no effective workaround. To power off
the PPAR, execute the poweroff(8)
command on the XSCF.
[How to restore]
Execute the poweroff(8) command on the
XSCF to power off the PPAR.
RTIF2-
140808-004
xA PCI Express correctable error may
occur if you connect a PCI Express
expansion unit (connected by PCI
Express Gen1), which is an IHV product,
to a SPARC M10-1.
There is no effective workaround.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 201594

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English