Fujitsu M10 Product Notes

Table 3-9
Problems resolved in XCP 2230 (continued)
SPARC M10-
RTINo. 1 4 4S Description Worka rou nd
RTIF2-
140813-001
xx xWhen an attempt is made to install
Oracle Solaris via vnet, installation menu
activation may take one hour or more in
the following case: the network speed
between the SPARC M10 system chassis
and the installation server is exceeding 1
Gbps or the system consists of multiple
SPARC M10-4Ss.
[Example] Network
installation on a
SPARC M10-4S via vnet
{0} ok
boot net:dhcp - install
Boot device: /virtual-devices@100/
channel-devices@200/network@0:dhcp
File and args: - install
<time unavailable> wanboot info: WAN
boot messages->console
<time unavailable> wanboot info:
configuring /virtual-devices@100/
channel-devices@200/network@0:dhcp
<time unavailable> wanboot info:
Starting DHCP configuration
<time unavailable> wanboot info: DHCP
configuration succeeded
<time unavailable> wanboot progress:
wanbootfs: Read
368 of 368 kB (100%)
<time unavailable> wanboot info:
wanbootfs: Download complete
Wed Aug 13 06:24:51 wanboot progress:
miniroot: Read 4864 of 243471 kB (1%)
(*1)
*1 This step takes time.
Install Oracle Solaris from a vdisk or
DVD-ROM created using an ISO image.
RTIF2-
140815-001
xIf the system board is deleted by the
dynamic reconfiguration of physical
partitions (DR), the monitoring of Host
Watchdog for logical domains may stop.
After the system board is deleted, to
restart the monitoring of Host Watchdog,
reboot one of logical domains in the
physical partition (PPAR).
RTIF2-
140819-001
xx xWhen the XSCF is restarted or the input
power is turned on again, the following
problem may, in rare cases, occur: ntpd is
left inactiv e and, as a result, sync hro niz at io n
of the XSCF time with the NTP server
time fails. To confirm whether ntpd is
inactive, execute the showntp -l
command. If the message "NTP is
unavailable." appears, ntpd is inactive.
This problem does not occur if the setting
specifying the XSCF as an NTP client or
NTP server is disabled.
There is no effective workaround.
[How to restore]
If the setting specifying the XSCF as an
NTP client or NTP server is enabled and
ntpd is inactive, execute the rebootxscf(8)
command to restart the XSCF.
Chapter 3 Information on Software 95

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English