Fujitsu M10 Product Notes

Table 3-15
Problems resolved in XCP 2090 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
130305-009
x x x Suppose that 129 or more IP addresses of
the trap hosts are registered by the
setsnmp addtraphost or setsnmp
addv3traphost command. Then,
executing the showsnmp(8) command
displays each of the SNMPv1, SNMPv2,
SNMPv2-inform, and SNMPv3 trap
hosts, up to a maximum of 128 entries.
Similarly, suppose that 129 or more
entries
are registered by the setsnmpusm
create, setsnmpvacm creategroup,
setsnmpvacm createview, or setsnmpvacm
createaccess command. Then, executing
the showsnmpusm or showsnmpvacm
command displays no more than 128
entries for a user, view, group, and access.
There is no effective workaround.
When 129 or more data entries are
registered by the setsnmp(8),
setsnmpusm(8), or setsnmpvacm(8)
command without an abnormal end, the
data entries have been registered
successfully.
RTIF2-
131023-003
xx xOID of scfDomainInfoGroup is
duplicated and defined in the MIB
definition file for XSCF expansion.
Therefore, any attempt to install the MIB
definition file for XSCF expansion in the
server management software (e.g.,
JP1/Integrated Management manufactured
by Hitachi) may fail.
Delete the line of text of the duplicated
OID from the MIB definition file for
XSCF expansion. Then, install the MIB
definition file for XSCF expansion again.
The line of text to be deleted is that in
which scfDomainInfoGroup containing
"::= { scfMIBObjectGroups 14 }" is defined.
[Example]
For the MIB definition file for XSCF
expansion (XSCF-SP-MIB_2050.mib),
delete the following lines 3558 to 3566.
--------------
3558: scfDomainInfoGroup OBJECT-
GROUP
3559: OBJECTS {
3560: scfDomainNumber, scfPPARId,
scfDomainName,
3561: scfDomainStatus
3562: }
3563: STATUS current
3564: DESCRIPTION
3565: "A collection of objects providing
PPAR information."
3566: ::= { scfMIBObjectGroups 14 }
--------------
RTIF2-
131107-001
xIf the XSCF BB control cable is faulty or
loose or if an XSCF failure occurs, it may
take several hours to disconnect or reset
the power supply of the physical
partition (PPAR) consisting of multiple
SPARC M10-4S units.
There is no effective workaround.
Chapter 3 Information on Software 117

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English