Fujitsu M10 Product Notes

Table 3-5
Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
130410-003
xIf a physical partition (PPAR) is powered
on in the system that satisfies all the
following conditions, other PPAR may
also be powered on.
- The power supply interlocking is
enabled with the setremotepwrmgmt
(8) command.
- A node is created whose SubNodeID is
not set in a power supply interlocking
management
item.
- Multiple PPARs are configured.
- When power supply interlocking is not
necessary
Disable power supply interlocking with
setremotepwrmgmt -c disable and then
delete the power supply interlocking
setting with the clearremotepwrmgmt
(8) command.
- When power supply interlocking is
necessary
If the system has multiple PPARs,
create a management file for power
supply interlocking by specifying a
PPAR-ID as a SubNodeID, and then
register the power supply interlocking
setting with setremotepwrmgmt -c
config.
RTIF2-
130516-002
xIf XSCF switching or an XSCF reset
occurs while the physical partition
(PPAR) is being powered off, it may be
impossible to turn off the power.
There is no effective workaround.
While powering off PPAR, do not use the
switchscf(8) command to perform XSCF
switching or the rebootxscf(8) command
to perform an
XSCF reset.
RTIF2-
130516-004
xIf a hardware failure occurs in a 4BB or
greater configuration, automatic cluster
switching may fail.
If 16 or more guest nodes are incorporated
into a single cluster, the following
warning message may be output to the
console of the control domain.
SA SA_xscf????.so to test host ??? failed
If automatic cluster switching fails,
follow the procedure in the manual of the
cluster software to perform switching
manually.
RTIF2-
130516-006
xIf XSCF switching occurs while multiple
physical partitions (PPARs) are being
powered on at the same time, it may take
more than usual to power them on.
There is no effective workaround.
Do not switch an XSCF by using the
switchscf(8) command while PPARs are
being powered on.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 201544

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English