Fujitsu MCE3064AP - 4.3.1.9 ATA Features Register; 4.3.1.10 ATAPI Features Register; 4.3.1.11 ATA Sector Count Register; 4.3.1.12 ATAPI Interrupt Reason Register

C156-E142-02EN 4 - 9
4.3.1.9 ATA Features register
This register is used for the SET FEATURES command.
4.3.1.10 ATAPI Features register
This register's bits are defined as shown below.
Table 4.11 Bit definitions of ATAPI Features register
76543210
Reserved
OVERLAP
DMA Write
! All values in bits 7 to 2 are ignored.
! OVERLAP is ignored.
! When DMA is 1, the ODD performs DMA transfer for data.
4.3.1.11 ATA Sector Count register
This register is used for the SET FEATURES command.
4.3.1.12 ATAPI Interrupt Reason register
This register's bits are defined as shown below.
Table 4.12 Bit definitions of ATAPI Interrupt Reason register
76543210
Reserved
(0b)
Reserved
(0b)
Reserved
(0b)
Reserved
(0b)
Reserved
(0b)
RELEASE
IO CoD Read
! A value of 1 in RELEASE indicates that the ODD released the ATA bus before completion of
the current command.
! IO indicates the direction of data transfer. See Table 4.13.
! CoD indicates the type of transfer. See Table 4.13.