Notes on USB Power Delivery ( USB-PD)
Notes on USB Power Delivery (US
B-PD)
USB-PD is a function defined by the USB Implementers F oru m, In c., in accordance with the current
specification of USB-PD Version 2.0. It provides a way to deliver current via the USB-C cable, and
charge power of up to 65 W, a convenient w ay for you to recharge your Notebook or Tablet.
For this, the monitor must be in operating mode, readiness mod e or All-in-One
mode. No USB-PD is po ssible when disconnected.
To ensure security and compatibility, only the supplied USB-C cable or an
equivalent certified USB-C cable must be used.
The USB-PD function is protected by an electrical overcurrent device. If current exceeds
4 A, USB-PD is switched off as a precautionary measure. In this case, disconnect the
device, check it for defects and reconnect it to be able to use USB-PD again.
This monitor was tested using systems developed by FUJITSU, requiring power
delivery of max. 65 W via U SB-PD. For other systems that only accept their own
brand of USB-PD charging device due to specific pow er delivery directives, the
USB-PD support for this monitor may be limited. Please note that any restriction
of this kind on the system will be due to the brand involved.
On the manufacture r’s website of y our Notebook or Tablet, check that the latest firmware
is installed for your USB-PD controller. By installing more r ecen t USB-PD controller
firmware, you can avoid compatibility problems with charging operations.
Only one USB p ort on this monitor supports USB Power Delivery with up t o 65 W. Th e other USB
ports deliver conventional USB charge current. You can identify proper conne ction by this symbol:
Symbol Port Power supply
USB-C upto65W(USB-PD)
USB-C
up to 15 W
USB-A
up to 4.5 W
Fujitsu 47
To Next Page
Loading...
