Fujitsu PRIMERGY RX200 S3 Service Supplement

26 Service Supplement RX200 S3
Replacing the power-sharing board Replacing components
2. Only loosen the screw marked (2) in figure 10 on page 25, and pull the
housing a little in the direction of the back of the server (see number (3)).
3. Remove the power-sharing board.
To install the power-sharing board follow the above steps in reverse.

Fujitsu PRIMERGY RX200 S3 Specifications

General

Number of Processors	2
Storage	Up to 6 x 3.5" SAS/SATA HDD
RAID Support	RAID 0, 1
Network	Dual Gigabit Ethernet
Form Factor	1U Rack
Power Supply	Hot-plug redundant power supply