Fujitsu Primergy RX200 S4 - Replacing the Front Panel Module

20 Service Supplement RX200 S4
Replacing the front panel module Replacement routines
© cognitas. Gesellschft für Technik-Dokumentation mbH 2008 Pfad: J:\RX200S4\Doku\Suppl\EN\rx200s4-ss-en.k04
4.2 Replacing the front panel module
The front panel module consists of the front panel board, an operating panel
and a holder. These components are already pre-assembled.
Ê Open the server as described in the section “Preparation” on page 17.
Ê Lift up the air duct and take it out as described in the section “Removing the
air duct” on page 19.
Figure 6: Loosening the screw
Ê Loosen the screw (1) and unplug the front panel cable (2).
2
1