56 Options Guide RX200 S6
Expansion cards and iBBU
9.1 Installing an expansion card
The server has three slots for PCIe expansion cards. These are integrated in
the system using riser cards (see positions (1) - (3) in figure 24).
The individual slots can be equipped as follows:
– Riser card #1: PCIe x8, standard and low-profile expansion cards
– Riser card #2: PCIe x8, only low-profile expansion cards
– Riser card #3: PCIe x4, internal, only for (low-profile) RAID controllers
I For the installing order see the configurator of the server:
https://sp.ts.fujitsu.com/dmsp/docs/cnfgrx200s6.pdf
(for the EMEA market)
http://primeserver.fujitsu.com/primergy/system.html
(for the Japanese market)
Removing the riser card holder
Ê Open the server as described in chapter "Preparation" on page 25.
Figure 24: Position of riser card holders 1-3
Ê If necessary, disconnect the cables from the relevant expansion card.
Ê Lift the required riser card holder upward and remove it.
2 3
1
To Next Page
Loading...
