RX200 S6 Options Guide 61
Expansion cards and iBBU
9.2 Installing a modular RAID controller
A modular RAID controller can be installed in the server as an option.
Riser card #3 (see figure 24 on page 56) is intended solely for this purpose.
Removing riser card holder with riser card #3
Ê Lift the required riser card holder with riser card #3 upward and remove it.
Installing a modular RAID controller
Ê Please read the documentation supplied with the modular RAID controller.
Ê Connect any required cables to the modular RAID controller.
Figure 31: Installing the modular RAID controller in riser card #3
Ê Carefully push the modular RAID controller into the slot of riser card #3.
I Make sure that the modular RAID controller is positioned correctly
(see circle).
Installing the riser card holder with riser card #3
Ê Position the riser card holder over the relevant slot on the system board.
Ê Carefully push the riser card holder into the slot by pressing on the green
points.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 73.
To Next Page
Loading...
