42 Options Guide RX200 S6
Processors
6.3 Replacing the heat sink
Ê Open the server as described in the chapter "Preparation" on page 25.
Ê Remove the air duct as described in the section "Removing the air duct" on
page 29.
Ê Remove the four screws of the heat sink in a crossover pattern (see figure 11
on page 39).
Ê Loosen the heat sink carefully by turning it back and forth. Then lift it up and
off.
Ê Clean the upper side of the processor using a lint-free cloth.
I New heat sinks come with thermal paste already applied. When reusing
used heat sinks, you need to apply thermal paste.
Ê Place the heat sink on the processor (see figure 10 on page 38).
Ê Fasten the heat sink by tightening the four screws in a crossover pattern (see
figure 10 on page 38).
Ê Reinstall the air duct as described in the section "Installing the air duct" on
page 73.
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page 73.
To Next Page
Loading...
