Fujitsu PRIMERGY RX200 S6 - 5.3 Configuring the server

74 Options Guide RX200 S6
Completion
– The plastic pin of the air duct must fit into the groove of the system board
(see circle).
Figure 44: Position of the plastic pin of the air duct
– The air duct must be hooked into the fan brackets on the left side and the
right side as seen from the front (in this case, the right side):
Figure 45: Air duct (right side)
Slot #3
DIMM CPU #1
Fan #1/#2
Fan #3/#4