RX600 S6 Service Supplement 39
Replacement routines
– SAS/SATA RAID controller card (see section "Replacing the SAS/SATA
RAID controller card" on page 26)
– UFM (see section "Replacing the UFM" on page 51)
Figure 19: Removing the hot-plug PCI divider insert
Ê Remove the hot-plug PCI divider insert as follows:
– Pull the safety pin (see arrow (1) in figure above) of the PCI divider insert
upward.
– Push the hot-plug PCI divider insert to the servers rear side and lift it out
of the housing (see arrow (2) in figure above).
0
/
To Next Page
Loading...
