RX600 S6 Service Supplement 29
Replacement routines
4.7 Replacing the control panel
Ê Open the server as described in section "Opening the server" on page 21.
Ê Remove the following components:
– all of the fans (for a description see the Operating Manual)
– all memory boards and memory dividers (for a description see the
Options Guide)
I Make a note about the slot from which you pulled each memory
board for you have to replace it back into the same slot.
Ê Remove the fan box (see page 27).
Ê Unplug the cable from the back of the control panel.
Figure 11: Removing the control panel
Ê Press on the plastic tabs (1) on both sides of the control panel and push it
outward (2).
To install the control panel follow the above steps in reverse.
/
/
0
To Next Page
Loading...
