48 Service Supplement RX600 S6
Replacement routines
Ê Pull the defective power distribution board in the direction of the arrow and
lift it out of the housing.
Installing the power distribution board
Ê To install the new power distribution board follow the above steps in reverse.
4.13 Replacing the TPM
TPM is the short form for Trusted Platform Module.
V CAUTION!
Advise the customer that he must provide you with TPM backup copies.
For security reasons, the TPM must be restored/re-saved by the
customer.
If the customer does not have a backup copy available, inform him that
replacing the TPM board will cause him to lose all his data.
Ê Open the server as described in section "Opening the server" on page 21.
Ê Remove the system board as described in section "Replacing the system
board" on page 38.
Ê Lay the system board on a soft, antistatic surface with its component side
facing down.
Figure 27: Locating the slotted lower end of TPM screw
Ê Locate the slotted lower end of the TPM screw (see circle).
To Next Page
Loading...
