22 Service Supplement RX600 S6
Replacement routines
Ê Swivel the two quick release levers (1) and pull the server carefully out of the
rack as far as possible (2).
V CAUTION!
Do not use the pulled-out server as a surface on which to put things
or as a work surface, especially do not lean on or against it.
Ê Undo the little screw on the housing cover.
Ê Push the two green touchpoints on the cover and move the cover backward
by approximately 2 cm.
Ê Lift off the housing cover.
4.1.2 Closing the server
Figure 3: Placing the housing cover
Ê Place the housing cover onto the server such that it projects approximately
2 cm at the back (see circle in figure above).
Ê Push the housing cover in the direction of the arrow until it engages.
Ê Fasten the little screw on the housing cover.
To Next Page
Loading...
