RX600 S6 Service Supplement 35
Replacement routines
4.10 Replacing the optical drive
Ê Open the server as described in section "Opening the server" on page 21.
Ê Remove all memory boards and memory dividers (for a description see the
Options Guide).
I Make a note about the slot from which you pulled each memory board
for you have to replace it back into the same slot.
Ê Remove the memory rug (see figure 13 on page 32).
Figure 16: Location of the optical drive connector
The optical drive is connected to the hot-swap backplane via a green connector
(see oval in figure above).
To Next Page
Loading...
