32 Service Supplement RX600 S6
Replacement routines
4.9 Replacing the hot-swap backplane (HSBP)
Ê Open the server as described in section "Opening the server" on page 21.
Ê Remove all memory boards and memory dividers (for a description see the
Options Guide).
I Make a note about the slot from which you pulled each memory board
for you have to replace it back into the same slot.
Figure 13: Removing the memory rug
Ê Remove the memory rug by undoing the four screws (see arrows in figure
above).
To Next Page
Loading...
