Fujitsu PRIMERGY RX600 S6 - Page 53

RX600 S6 Service Supplement 53
Replacement routines
Figure 33: Preparing the UFM
Ê Remove the nylon screw from the new UFM (1).
Ê Remove the UFM spacer (2).
Ê Connect the new UFM to the system board and the remaining UFM spacer
(see figure 30 on page 51)).
Ê Fasten the UFM to the UFM spacer with the nylon screw.
Ê Reinstall the I/O riser card.
Ê Close the server as described in section "Closing the server" on page 22.
2
1