ServerView BX900 Management Blade 23
3.3.4.6 Server Blade Temperature
This option provides information on the server temperature. Some of the parameters displayed can also be set by
the user:
3.3.4.7 Server Blade NIC Information
This option displays the IP and MAC address of the server blade.
3.3.4.8 Server Blade Watch Dog
This option is used to configure the watchdog timers for the server blade. There are two timers that can bet set
here:
Parameter Description
Server Temperature Sensor Designation Displays the designation of the temperature sensor for the
server blade.
Server Temperature Sensor Status Displays the status of the temperature sensor. The values
displayed will be:
– SENSOR_DISABLED
– SENSOR_FAIL
– WARNING_TEMP_WARM
– CRITICAL_TEMP_WARM
– NOT-AVAILABLE
Server Temperature Upper Warning Level This parameter can be set to configure the upper warning level
of the temperature sensor for the server blade.
Server Temperature Upper Critical Level This parameter can be set to configure the upper critical level
of the temperature sensor for the server blade.
Server Temperature Lower Warning Level This parameter can be set to configure the lower warning level
of the temperature sensor for the server blade.
Server Temperature Lower Critical Level This parameter can be set to configure the lower critical level
of the temperature sensor for the server blade.
Server Temperature Current Value Displays the current temperature value for the server blade.
Timer Description
Server Blade Software Watchdog This timer is used to monitor the operation system and the software applica-
tions. A watchdog timer agent that resets the timer must be implemented in
the operation system. When the time-out is reached, a time-out routine will
be started.
Server Blade Boot Watchdog This timer is used to monitor the server blade POST. It will be reset by the
BIOS in periods configured within the POST code. When the time-out is
reached, a time-out routine will be started.
To Next Page
Loading...
