Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
61
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
2 Load the Carrier Sheet face-down in the ADF paper chute
(feeder), as shown below.
Secure the Carrier Sheet with the side guides to avoid skewing.
3 In the scanner driver, configure the scan settings for using
the Carrier Sheet.
For details, refer to the scanner driver's Help.
4 Scan the document with the image scanning application.
For details, refer to the manual of the image scanning application.
ATTENTION
z The image is output at the center of the page in the size
specified in [Paper Size].
z When [Automatic detection] is specified for [Paper Size], the
closest standard size is selected from the same drop-down list.
Note that the size of the image may become smaller than the
original document depending on the document scanned, or part
of the image may appear missing.
Example: When an A5 size image is printed in the center of an
A4 size document
DThe image is output in A5 size.
To output the scanned image in the actual size of the document,
specify the document size for [Paper size].
HINT
In the following cases, place a blank (white) sheet of paper
underneath the document when scanning.
z The scanned image is not output in the correct size when
[Automatic detection] is selected in the [Paper size] drop-down
list
z Shadows appear around the edges of the scanned image
z Black lines appear around the edges of a uniquely shaped
cutting
z Colors outside the document appear on the scanned image
To Next Page
Loading...
Need help?
General
