Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Index
Contents
TOP
62
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Various Ways to
Scan
How to Use the
Operator Panel
Long Page Scanning
Documents with a length up to 3,048 mm (120 in.) can be
scanned by long page scanning.
Document sizes that can be scanned will vary according to the
image scanning application.
For details, refer to the manual of the image scanning
application.
1 Load a document in the ADF paper chute (feeder).
For details, refer to "Chapter 2 How to Load Documents" (page 38).
2 In the scanner driver, configure the scan settings to scan
the paper size of the long page.
For details, refer to the scanner driver's Help.
For some image scanning applications, the scanner driver's setup
dialog box may not appear.
ATTENTION
z Long page documents should be loaded one sheet at a time in
the ADF paper chute (feeder).
z When you scan long pages, take note of the following.
- Loading
Hold the document with your hand so it does not fall out of the
ADF paper chute (feeder).
-Removing
Secure enough space around the stacker to prevent the
ejected sheet from falling off the stacker.
HINT
To scan documents longer than A4/Letter size, perform the
following:
z Pull out the chute extensions all the way.
For details, refer to "1.6 Setting Up the ADF Paper Chute
(feeder)" (page 27).
z Lift the stacker and stacker extension towards you.
For details, refer to "1.7 Setting Up the Stacker" (page 28).
To Next Page
Loading...
Need help?
General