Chapter 5 Daily Care
Appendix
Glossary
Introduction
Index
Contents
TOP
77
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Troubleshooting
Replacing the
Consumables
Scanner
Overview
Daily Care
Operational
Settings
Ultrasonic sensor (× 2)
Gently wipe the dirt and dust off the surface of the ultrasonic sensors.
Feed roller (× 2)/Eject roller (× 2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page 24).
2 When the operator panel is in ready status, open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page 25).
3 When you press the [Scan/Stop] button on the operator panel, the
feed/eject rollers rotate a certain amount.
4 Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the roller surface, and wipe horizontally.
Wipe the whole surface by pressing the [Scan/Stop] button to
rotate the rollers.
Make sure that it is cleaned properly because residue on the roller
will affect the feeding performance.
As a guideline, pressing the [Scan/Stop] button seven times will
rotate the feed/eject rollers one revolution.
If it is difficult to clean, use a cotton swab.
When you press the [Scan/Stop] button,
the feed/eject rollers rotate at the same
time. Be careful not to touch the rollers
with your hand while they are rotating.
To Next Page
Loading...
Need help?
General