4.3 Scanning Business Cards
ScanSnap S500 Operator's Guide 125
Various settings according to your needs
4
<Scanning procedure>
Operation
1. Load the business cards onto the scanner.
•
Load the business cards face down.
• When you scan more than one business card, set them together.
• Adjust the side guides so that they are touching the business card edges.
2. Press the [SCAN] button on the scanner.
⇒ Scanning will be started. After the scanning has finished, the "CardMinder" screen is
displayed.
• Do not connect or disconnect other USB devices during the scanning
operation.
• Do not close the paper chute or press the [POWER] button on the scanner
during the scanning operation.
• Do not switch the user to log in during the scanning operation.
• As the default setting, documents are scanned at "Duplex" mode when you
press the [SCAN] button. Using "ScanSnap Manager", you can set the
scanner to scan documents in "Simplex" mode by pressing [SCAN] button.
• You can also start scanning with the "ScanSnap Manager" icon on the
task bar.
*For details, refer to "3.4 Changing Scan Settings" (on page 53).
Paper chute
Business card
Side guide
[SCAN] button
To Next Page
Loading...
