Fujitsu ScanSnap S510 User Manual

234
Turn on the scanner before cleaning the following locations, and clean the following rollers
while rotating them.
• Feed rollers (2 pieces)
Clean lightly taking care not to roughen the surface of the rollers. Take particular care in
cleaning the feed rollers since black debris on the rollers adversely affect the pickup
performance.
• Eject rollers (2 pieces)
Clean lightly taking care not to roughen the surface of the rollers.
Take particular care in cleaning the eject rollers since black debris on the rollers adversely
affect the pickup performance.
To rotate the feed rollers and the eject rollers, press the [POWER] button while holding
down the [SCAN] button.
As a guideline, six presses of the [POWER] button make the rollers to rotate one full turn.
3. Close the ADF.
ATTENTION
Connect the AC adapter and AC cable only when cleaning the feed rollers and
eject rollers.
ATTENTION
After closing the ADF, make sure that it is completely closed. Otherwise, paper
jams or other feeding errors may occur.
1. Hold down the [SCAN] button.
2. Press the [POWER] button
while holding down the [SCAN]
button.
⇒ The rollers rotate.
Paper chute
ADF

Fujitsu ScanSnap S510 Specifications

General

Film scanning	No
Color scanning	Yes
Input color depth	- bit
Maximum scan size	216 x 356 mm
Scanner type	Sheet-fed scanner
Sensor type	CCD
ISO A-series sizes (A0...A9)	A4, A5, A6
ISO B-series sizes (B0...B9)	B5, B6
Maximum ISO A-series paper size	A4
Auto document feeder (ADF) input capacity	50 sheets
USB version	2.0
Standard interfaces	USB 2.0
Minimum storage drive space	512 MB
Minimum system requirements	Windows 2000/ XP/ Vista
Sustainability certificates	ENERGY STAR
Power requirements	AC 100V to 240V, 50 / 60 Hz
Operating temperature (T-T)	5 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Certification	RoHS

Weight and Dimensions

Weight	2700 g