Troubleshooting and tips
The cursor d oes not correctly follow the
pen movements
Cause
Fault elimination
Pen incorrectly calibrated
► Calibrate the pen as shown under Hardware
and Sound / Tablet PC Settings in the Control
Panel, see "
Setting the pen", Page 34 and
"
Calibrating the pen", Page 35.
Pen input not working
Cause
Troubleshooting
Incorrect drive r installed.
► If your device is one which can only be
operated using the pen, install the driver for
the standard mod el.
or
► If your device is one which can be
operated using the pen and by finger,
install the driver for the "Dual Digitizer"
model.
The Tablet PC do
es not start after switch on
TheTabletPC
Cause Troublesho oti
ng
The battery is
not installed correctly.
► Check whether the battery is installed
correctly in its compartment.
► Switch on the Tablet PC.
The battery is dead.
► Charge the battery.
or
► Insert a charged battery.
or
► Connect the mains adapter to the Tablet
PC.
The power adapter is not connected correctly.
► Check w hether the m ains adapter is
connected correctly to the Tablet PC.
► Switch on the Tablet PC.
70 Fujitsu Technology Solutions