Fujitsu UTB-GCA - 3-1. BASIC FLOW OF OPERATION

14
3. BASIC OPERATION
3-1. BASIC FLOW OF OPERATION
This section explains the basic flow of operation.
■ To start operation
SET
ON
ON
OFF
OFF
Each setting button ON / OFF SET
ALL / GROUP
ON
ON
OFF
OFF
ON / OFF
SET
SET
ALL / GROUP
* When several control items need to be changed, complete all the changes in and then
send in .
* Use the following sequence to make changes without start-
ing the unit.
■ To stop the operation
Select the
control mode.
Change each of
the settings.
Set the power
supply to on
setting.
Transmit, the
newly set
information.
Select the
control mode.
Set the power
supply to off
setting.
Transmit, the
newly set
information.
Notes • All the indoor units can be turned on / off at the same time with this central remote controller. For details,
refer to “5-1. ALL OPERATION/ALL STOP.”
• Please refer to sections 4, 5, 6 for details about specific operations.
UTB-YCA.GCA_p12-18.p65 05.9.6, 2:35 PM14