56
6. TIMER SETTING
METHOD
The timers built in the central remote controller have four different operating modes. They are
shown as the following and can be selected only one from the four modes.
• OFF TIMER ........... Stop the indoor units at the set time.
• ON TIMER ............. Start the indoor units at the set time.
• WEEKLY TIMER .... Weekly timer setting function. Up to two on / off settings for each day of the
week. (Refer to 6-3. WEEKLY TIMER)
Notes Timer settings in multiple locations
• If the on timer setting is also performed by the standard remote controller, the standard remote controller
timer will have priority.
(If there is an on command from the central remote controller to the indoor units, the indoor units will not
start to operate.)
• If timer settings are performed simultaneously at central remote controllers at multiple locations (central
remote controller 1, central remote controller 2,...), the indoor units will follow the command of the central
remote controller that the last control signal will send out.
Stop timer operation
• An electricity failure will cancel all set time. The setting will become non stop setting.
6-1. OFF TIMER
Enter the control mode to select the central control
number (the indoor units) for the setting.
Refer to “3-3. CONTROL MODE” for information
about control modes.
CHECK
ACL
MASTER
ENERGY ANTI
FAN
TIMER
SET
TIMER
DELETE
TIMER
DAY
CLOCK
ADJUST
DAY OFF
TEMP.
MEMORY
OPERATION
MEMORY
TEST
SET
CENTRAL
DELETE
BACK
GROUP
ZONE
ON OFF
TIME
CONTROL
CONTROL
FILTER
RESET
CONTROL
FREEZE
COPY
TIMER
MODE
SAVE
SETTING SETTING
To Next Page
Loading...
Need help?
General
