29
4. CENTRAL
CONTROL METHOD
4-4-2. To end zone operation
Enter the control mode to select the central control
group (the indoor units) whose zone operation is to
be ended.
Refer to “3-3. CONTROL MODE” for information
about control modes.
Press
ZONE
once again. will appear.
It is necessary to transmit the newly set information
to the relevant indoor units. Refer to steps 4, 5 and
notes of “3-3. CONTROL MODE” for details.
Note The zone function can be used only with the following indoor units.
A TFAMF
A TFBMF
AU TFBMF
To Next Page
Loading...
