42
5. OPERATION
SETTING METHOD
It is necessary to transmit the newly set information
to the relevant indoor units. Refer to steps 4, 5 and
notes of “3-3. CONTROL MODE” for details.
Notes • At the beginning the vertical airflow direction is set automatically as shown, in accordance with the type of
operation selected.
During cooling mode: Horizontal flow 1
During heating mode: Downward flow 4
• The air direction can be adjusted within the range shown below.
• During AUTO mode operation, for the first minute after beginning operation, airflow will be horizontal flow
1; the air direction cannot be adjusted during this period.
• If the direction setting is set at the same time as operation mode setting, the indoor unit will follow the flow
direction setting that has been set.
To Next Page
Loading...
