3
20
User Manual
Configuration
PIN AP
If the PIN AP WPS configuration method is selected, the AP automatically gen-
erates a PIN. Click OK to save the configuration and to enter the generated PIN
in the wireless client WPS program. In this case, start the process start from the
wireless client WPS program.
Push Button W500 supports software PBC (calling up WPS mode from a software button)
and hardware PBC (calling up WPS mode by pressing a button on the device).
To use software PBC, select
WPS Configuration Mode Push Button and en-
ter the pre-shared key. Click Start PBC to start the WPS process. If you wish to
use the hardware WPS button, the
WPS Enable check box must be selected.
Keep the Hardware WPS button depressed for at least three seconds. After re-
leasing the button the AP switches to the WPS mode for two minutes. During
these two minutes you have to arrange for the wireless client to establish a WPS
connection with the AP using the same PBC mode.
3.2.2 Wireless Settings
In this menu you can undertake changes to the settings for wireless network op-
eration. In GENERAL SETTINGS changes can be made to OPERATION MODE,
NETWORK NAME, CHANNEL and WIRELESS MODE, in ADVANCED SETTINGS additional
parameters such as
OUTPUT POWER or DATA RATE MANAGEMENT are accessible
for changing.
To Next Page
Loading...
Need help?
General
