User Manual
9
Hardware Installation
2
2 Hardware Installation
This chapter describes the initial setup of the access point (AP).
2.1 Checking for Completeness
Make sure the following parts are present prior to installation:
■ W500
■ Ethernet cable
■ Power supply unit
■ Product CD
If any of these parts are missing or damaged, please contact your vendor for
further assistance.
2.2 System Requirements
Required for installing W500:
1. A power socket (100~240 V, 50~60 Hz) for power supply to the access
point.
2. An Ethernet network.
To Next Page
Loading...