3. INITIAL SETTINGS
3-4
1 key: [Mode Setup]
Set the AMS mode.
[Legacy]: Select when no AMS is connect-
ed.
[AlertIF1]: Select when AMS is connected.
For [AlertIF1], an option window is
shown. To return to the [AMS Setup
Menu] from this window, press the E key
twice.
[Distress Alarm Stop Enable]: The AMS
can stop the alarm sound when the Dis-
tress Priority message is received.
[Distress Alarm Stop Disable]: The AMS can not stop the alarm sound when the
Distress Priority message is received.
2 key: [MY SFI Setup]
Set the SFI of FELCOM18. Enter the four-
digit number that follows “CS”.
3 key: [AMS SFI Setup]
Set the SFI of the AMS. Enter the two alpha-
bet characters and four-digit number.
4 key: [Error Log]
The [Error Log] compiles AMS re-
lated errors. To delete an error log
entry, select the log then press
the 1, Enter key.
The error log holds 4294967296
entries. When that count is
reached, the message "LIMIT
MAX" appears.
7. Press the Esc key several times to close the menu.
[ Mode Setup ]
2. AlertIF1
E: Exit
Enter AMS Mode No.:
Command Window
1. Legacy ON
[ Mode Setup ]
2. AlertIF1
E: Exit
Enter AMS Mode No.:
Command Window
1. Legacy ON
[ AlertIF1 Option ]
2. Distress Alarm Stop Disable ON
E: Exit
Enter AlertIF1 Option No.:
Command Window
1. Distress Alarm Stop Enable
[ MY SFI Setup ]
0000 to 9998: SFI No.
E: Exit
Enter SFI No.:
Command Window
SFI CS0001
[ AMS SFI Setup ]
E: Exit
Enter SFI:
Command Window
SFI II0001
[ Error Log ]
Command Window
Datagram header error xxxxxxxxxx*
TAG block formatting error xxxxxxxxxx
TAG checksum error xxxxxxxxxx
TAG syntax error xxxxxxxxxx
TAG framing error xxxxxxxxxx
Sentence syntax error xxxxxxxxxx
Total 4294967295 LIMIT MAX
1. Log Clear
E: Exit
Enter JOB No.:
*: xxxxxxxxxx: Error log count
To Next Page
Loading...
