Furuno FELCOM18 Installation Manual

3. INITIAL SETTINGS
3-3
3.3 How to Set the Alarm Contact
1. Press the F8 and 1 keys to show the [System Setup] menu.
2. Press ↓ to select [Command Window], and then press the Enter key.
3. Enter the [Enter JOB No.:], then press the Enter key.
4. Enter the [PASSWORD:], and then press the Enter key.
[Main Menu] is highlighted.
5. Press the 2 key, and the Enter key.
6. Press a numeric key (1 to 4), then press the Enter key.
To detect the error on a unit, press 4 and Enter in order.
7. Press the 1, and Enter keys.
To return to the [External Alarm Setup] menu, press the E key.
8. Repeat steps 6 and 7 to set other alarm contacts.
9. Press the Esc key several times to close the menu.
3.4 How to Set up the AMS
Do the following to connect the AMS (Alert Management System).
1. Press the F8 and 1 keys to show the [System Setup] menu.
2. Press ↓ to select [Command Window], and then press the Enter key.
3. Enter the [Enter JOB No.:], then press the Enter key.
4. Enter the [PASSWORD:], then press the Enter key.
5. Press the 3 key, and the Enter key.
6. Press appropriate numeric key (1 to 4), then press the Enter key.
To return to the [AMS Setup Menu], press the E key at the setting window.
[
External Alarm Setup
]
2. Distress EGC : ON
3. Urgent EGC : ON
4. Unit Fault : OFF
E: Exit
Enter No.:
Command Window
1. Distress Message : ON
[
Unit Fault
]
2. OFF E: Exit
1. ON
[ AMS Setup Menu ]
2. MY SFI Setup
3. AMS SFI Setup
4. Error Log
E: Exit
Enter JOB No.:
Command Window
1. Mode Setup

Furuno FELCOM18 Specifications

General

Brand	Furuno
Model	FELCOM18
Category	Marine Equipment
Language	English