Furuno FELCOM18 - Page 29

4. HOW TO INSTALL OPTIONAL EQUIPMENT
4-3
4.2.2 OP16-59 (for connector ports)
OP16-59 (001-180-080)
USB port
Name Type Code No. Qty
Sponge for Dsub 16-023-3531 100-369-600-10 1
Cover for BNC 16-023-3534 100-369-630-10 1
Cover for USB 16-023-3535 100-369-641-10 1
USB Support 16-023-3536 100-369-650-10 1
Sponge for BNCR 16-023-3541 100-369-690-10 1
Dummy Plate 9P 16-023-3542 100-368-190-10 1
Dummy Plate 15P 16-023-3543 100-369-700-10 1
Dummy Plate 25P 16-023-3544 100-369-710-10 1
Binding Screw #4-40UNCX3/16 000-176-619-10 6
Attach the cover for USB
(16-023-3535) to the USB
connector, then connect it to
the terminal unit.
Cover for USB (triangle
mark should be upward.)
Cover for USB (triangle
mark should be upward.)
Fasten two binding screws
(pre-attached) to fix the USB
support (16-023-3536) as
shown right.
USB support
USB support
1
2