Furuno FSV25 - 2.5 Transceiver Unit

2. WIRING
2-9
2.5 Transceiver Unit
2.5.1 How to connect the IF unit
The transceiver unit is supplied with an earth plate (50 mm width, 1.5 m length) in the
installation materials. Use the two wing nuts to secure the plate and connect the trans-
ceiver ground plate to the ship’s earth.
Pass the IF unit cable (10S2380) through the cable clamp on the transceiver unit and
attach the 14P connector (CN-B101).
TB-B101
S10-20-10/20 (x 10)
P1
(64 pin)
Secure
cables
inside
cable
clamp
Secure
cables
inside
cable
clamp
Secure
shielded
section with
steel
clamps
IF unit (10S2380)
Hull unit (10CA10053)
Processor unit (FR-FTPC-CY)
Power
1
2
3
4
5
6
7
8
9
10
Cable
number
Insert transducer cables 1 ~ 10 as shown
and secure them using the cable clamp
TRX-10
CN-B101
CN-B103
CN-B102
Connector
fitting
TRX-1
P2
(40 pin)
Earth plate
Transducer cable clamps
480
5
40
Anticorrosive sheath
Shield
Vinyl sheath
Cable jacket
Cores
Insulating tape
Expose cores then wind
shield around armor.
Procedure
1. Twist core.
2. Insert terminal opener and push.
3. Insert wire into hole.
4. Release terminal opener.
5. Pull wire to confirm it is correctly inserted.
Terminal opener
Push
Wire
How to
attach
WAGO
connectors
Twist