1. HOW TO INSTALL THE SYSTEM
1-9
1.3 Control Unit (FSV-2501)
The control unit can be installed in a console (flush mount) or on a desktop (with KB
fixture). Select a location considering the following points.
• Select a location where the controls can be easily operated.
• Locate the unit away from direct sunlight.
• Keep the unit away from water and water splash
• The length of the cable connected between the control unit and interface unit is 5 or
10 m. Select a location considering the length of the cable.
• Observe the compass safe distance (see "SAFETY INSTRUCTIONS" on page i) to
prevent interference to a magnetic compass.
1.3.1 How to install the control unit
Desktop installation, with KB fixture
1. Fasten the KB fixture to the selected location with self-tapping screws (5x20, 4
pcs.).
2. Connect a ground wire (1.25 sq., local supply) between the ground terminal at the
bottom of the unit and ship’s ground.
3. Set the unit on top of the KB fixture and fasten the unit with four binding screws
(M5x12) and wave washers.
4. Set the cosmetic caps to the fixing holes.
Set at rear
KB fixture
To Next Page
Loading...
