Furuno FSV25 - Page 18

1. HOW TO INSTALL THE SYSTEM
1-10
Flush mount
1. Prepare a hole in the mounting location referring to outline drawing shown below.
2. Make four pilot holes for self-tapping screws (5).
3. Peel the tape from the Flush mount gasket then attach the gasket to the rear of
the control unit.
4. Set the unit to the hole and fasten it with self-tapping screws (520, 4 pcs.) and
wave washers.
5. Connect a ground wire (1.25 sq., local supply) between the ground terminal at the
bottom of the unit and ship’s ground.
6. Set cosmetic caps to the fixing holes.
1.3.2 Control Unit FSV-853 (option)
Desktop installation, with keyboard fixture
1. Fix the keyboard fixture to the bottom of the unit with the screws (M412) supplied.
2. Attach rubber feet (2 pcs.) to the bottom of the unit.
3. Fix the unit to the mounting location with self-tapping screws (local supply).
Name Type Code No. Qty
Keyboard fixture 03-163-7821-1 100-306-291-10 1
Washer head screw M412 C2700W MBN12 000-163-192-10 6
Rubber foot M540 000-162-682-10 2
141±1
130±0.5
C18
351±1
340±0.5
4 - Pilot holes
Keyboard fixture
Rubber feet