Furuno NAVpilot-611 User Manual

www.furuno.co.jp
AUTOPILOT
NAVpilot-611
Installation Manual
TABLE OF CONTENTS
SAFETY INSTRUCTIONS.......................i
SYSTEM CONFIGURATION ..................ii
EQUIPMENT LISTS .............................. iii
1. INSTALLATION OF UNITS .......... 1-1
1.1 Control Unit FAP-6011..................... 1-1
1.2 Processor Unit FAP-5002................ 1-3
1.3 Rudder Reference Unit FAP-6112 ... 1-4
1.4 Remote Controllers (option) ............ 1-5
2. WIRING ....................................... 2-1
2.1 Wiring System ................................. 2-1
2.2 Processor Unit................................. 2-2
2.3 Control Unit ..................................... 2-7
2.4 Remote Controllers (option) ............ 2-8
2.5 Connection of Instruments FI-30 ... 2-11
2.6 Input/Output Sentences................. 2-12
3. ADJUSTMENTS........................... 3-1
3.1 How to Access the Installation Menu....
....................................................... 3-1
3.2 DOCKSIDE SETUP Menu .............. 3-2
3.3 SEA TRIAL Menu ...........................3-11
3.4 DISPLAY SETUP Menu ................ 3-16
3.5 DATA CALIBRATION Menu........... 3-18
3.6 Other Settings............................... 3-20
PACKING LISTS.................................A-1
OUTLINE DRAWINGS ..................... D-1
INTERCONNECTION DIAGRAMS ...S-1


Furuno NAVpilot-611 Specifications

General

Type	Autopilot
Display	LCD
Display Size	4.1 inches
Power Supply	12-24 VDC
Communication	NMEA 0183
Category	Marine Equipment
Compatibility	Furuno GPS
Control Modes	Auto, Standby
Steering Modes	Automatic, manual
Supply Voltage	12-24 VDC

Summary

Safety Instructions

System Configuration

Equipment Lists

Installation of Units

Control Unit Installation

Details installation of the FAP-6011 control unit.

Processor Unit Installation

Explains mounting and placement of the FAP-5002 processor unit.

Rudder Reference Unit Installation

Covers the installation of the FAP-6112 rudder reference unit.

Optional Remote Controller Installation

Describes the installation of optional remote controllers.

Wiring

Wiring System Overview

Details the overall wiring system and cable separation guidelines.

Processor Unit Wiring

Explains how to connect cables to the processor unit.

Control Unit Wiring

Describes connecting multiple control units to the processor.

Remote Controller Wiring

Details wiring for optional remote controllers.

FI-30 Instruments Connection

Explains connecting FI-30 instruments via NMEA ports.

Input/Output Sentences

Lists NMEA input/output sentences and ports.

Adjustments

Accessing the Installation Menu

Guides on entering the installation menu for setup.

DOCKSIDE SETUP Menu

Initial setup of the equipment through the DOCKSIDE SETUP menu.

SEA TRIAL Menu

Procedures for testing the autopilot at sea.

DISPLAY SETUP Menu

Configuration for display units and formats.

DATA CALIBRATION Menu

Offsetting sensor data for accurate readings.

Other Settings

Configuration of remote controllers, NMEA, and system options.

Interconnection Diagrams