TECDIS Installation Manual Page 2
GENERAL INTRODUCTION TO THE INSTALLATION MANUAL ................................. 4
STANDARDS COMPLIANCE .................................................................................................... 5
EQUIPMENT LISTS: ................................................................................................................... 6
INSTALLATION OVERVIEW................................................................................................... 7
SPECIFICATIONS: ...................................................................................................................... 8
CHAPTER 1: MOUNTING ....................................................................................................... 12
1.1 MONITOR UNIT ....................................................................................................................... 12
1.2 PROCESSOR UNIT .................................................................................................................... 16
1.3 CONTROL UNIT FURUNO RCU-018........................................................................................ 18
1.4 KEYBOARD AND TRACKBALL .................................................................................................. 22
1.5 ADDITIONAL UNITS ................................................................................................................. 23
1.6 TRACK CONTROL: ANSCHÜTZ NP 2025 PLUS ..................................................................... 28
1.7 NAUT AW: GYRO SENSOR INPUT REQUIREMENTS ............................................................. 29
CHAPTER 2: WIRING AND SIGNAL DISTRIBUTION ..................................................... 30
2.1 WIRING DIAGRAM (HT 405P4 TEL-A1): .............................................................................. 31
2.2 SIGNAL DISTRIBUTION DIAGRAM (INTERNAL DATA FLOW): .................................................. 32
2.3 PROCESSOR CONNECTORS, HT 405P4 TEL-A1 .................................................................... 33
2.4 ETHERNET CONNECTORS AND CABLE .................................................................................... 34
2.5 OTHER CONNECTORS .............................................................................................................. 35
CHAPTER 3: PARAMETER SETUP ...................................................................................... 36
3.1. SERVICE MODE (WINDOWS) .................................................................................................. 36
3.2. NMEA DATA SETUP ............................................................................................................... 36
3.2.1 INPUTS ................................................................................................................................... 37
3.2.2 SPEED .................................................................................................................................... 37
3.2.3 OUTPUTS ............................................................................................................................... 38
3.2.4 PORT ACTIVITY ..................................................................................................................... 38
3.2.5 RECEIVED DATA .................................................................................................................... 38
3.2.6 OTHER COM PORT CONNECTIONS ......................................................................................... 38
3.2.7 SUPPORTED NMEA SENTENCES ............................................................................................ 39
3.3 SPECIFICATION ....................................................................................................................... 41
3.3.1 SAVE AND RESTORE SETUP DEFAULT VALUES ........................................................................ 42
3.4 TECDIS NMEA AND TCP/IP SERVER .................................................................................. 43
3.5 CHART INSTALLATION / MISC ................................................................................................ 44
3.5.1 INSTALL, UPDATE OR REMOVE CHART DATABASES ................................................................ 44
3.5.2 ENTER VESSEL INFORMATION: ............................................................................................... 45
3.5.3 SEND REGISTRATION .............................................................................................................. 46
3.5.4 START C-MAP CHART MANAGER .......................................................................................... 46
To Next Page
Loading...
