Furuno TECDIS - Chapter 5: Miscellaneous; 5.1 Error Messages

TECDIS Installation Manual Page 60
Chapter 5: Miscellaneous
5.1 Error Messages
TECDIS includes automatic error detection in most functions. If it is possible, corrective
measures will be taken without requiring operator intervention. In case of critical errors, the
operator is notified. In addition to the possible error situations listed here, both the Windows
operating system and support routines may in some instances display error messages not listed.
Common to these error messages is that corrective measures (if possible) are initiated by
restarting the ECDIS. In the case of a system failure any error messages should therefore be
noted. If the ECDIS is not responding or appear to be malfunctioning, try restarting the ECDIS.
If this does not correct the error situation, notify your support contact.
10=Init required too much space Memory full or error. Try restarting ECDIS.
11=Bad init parameters System error, should not normally occur.
12=Data files not found Old data file has been erased or destroyed.
New (empty) data file is automatically
generated.
13=Open db cannot determine type of file Installation error, use of invalid data.
14=Data files appear to be corrupted Try restarting ECDIS to generate new data
file.
16=Could not create index file Hard drive error or full, try erasing old data.
17=Could not create data file Hard drive error or full, try erasing old data.
18=Tried to create existing index file System error, should not normally occur.
19=Tried to create existing data file System error, should not normally occur.
24=Could not close file System error, probably memory error.
46=File number already in use System error, should not normally occur.
47=c-tree has not been initialized System error, should not normally occur.
101=C-Map system files not installed Incorrect or incomplete installation.
102=No C-Map charts installed! Incorrect or incomplete installation.
103=No chart database set as default! Incorrect or incomplete installation.
104=g_manager->Init() failed System error, should not normally occur.
105=g_map->Init() failed System error, should not normally occur.
106=g_mini->Init() failed System error, should not normally occur.
107=Update successfully completed Update confirmation.
108=g_map->SetZoom() failed System error, should not normally occur.
109=g_map->SetScale() failed System error, should not normally occur.
110=g_mini->SetScale() failed System error, should not normally occur.
111=g_map->SetRotation() failed System error, should not normally occur.
112=g_mini->SetRotation() failed System error, should not normally occur.
113=g_map->AddBase() failed System error, should not normally occur.
177=Not TECDIS dongle License dongle found but not approved.
188=Error in periodic ID check No license dongle found or approved.
189=File read failed Error in license dongle.