TECDIS Installation Manual Page 77
• Specifications for JH 23T02 on page 8 added
• Mounting dimensions for JH23T02 added to chapter 1.1 (page 17 and 18)
• New chapter: 1.6 Track Control: Anschütz NP 2025 PLUS
Revision 1.7 (17.10.2007)
• Section 2.5 Processor connectors, HT405P4 TEL-A1 on page 37 updated with
information about ferrite placement.
• Section 3.2. NMEA data setup on page 41-44 updated with new illustration and
information about status color coding.
• Section 3.5.1 Install, update or remove chart databases on page 49-50 updated with
information about new function ‘Remove Licenses’.
Revision 1.8 (15.11.2007)
• General introduction to the installation manual updated with new configuration data file.
• Section 1.6 updated with minimum sensor and other connection requirements for Track
Control functionality, and requirements to ensure “freeze rudder” functionality.
• Section 6: Added checklists for Track Control system and installation notes
Revision 1.9 (16.04.2008)
• Changed heading for section 6.2 to include TECDIS AW
• Added new section 6.3 for additional TECDIS AW requirements checklist
• Old section 6.3 and 6.4 are now section 6.4 and 6.5
• New section 1.7 for NAUT AW gyro sensor input requirements
Revision 2.0 (20.01.2009)
• Updated to reflect changes in new software version 4.7.1
• Deprecated hardware options removed from equipment list, mounting and wiring
chapters.
Revision 2.1 (17.11.2009)
• “General introduction to the installation manual” updated to include internet switch and
installation checklist requirements.
• Section 2.3 Processor connectors, HT 405P4 TEL-A1 updated to include requirements for
internet switch.
• Chapter 6 “Checklists regarding installation” updated.
To Next Page
Loading...
