FUTABA T16IZ Short Manual

26
System mode
• System(FASSTest18CH etc.)
mode is displayed here.
Battery voltage for receivers
• In FASSTest/T-FHSS mode, it is
displayed. Receiver voltage
and Ext voltage display
The reception of the signal from the
receiver to the transmitter is shown.
• This does not affect ight.
Timer1, Timer2
• Timer is displayed here.
Tap the time button to start/stop the
timer. (When the screen is tapped for
1 second, timer is reset to the initial
value.)
Home Screen
Digital trim (T1 to T4)
• Trim position is displayed
here.
Model Name
• The model name that
is currently used is
displayed here.
RF Indicator
User's name
System timer
• This shows the accumulated time
since the latest reset. (Each model /
Total)
(Hour):(Minute):(Second)
This is the Home screen and descriptions of its menus. Use your nger to operate the touch screen.
→ (Menu)
• Model
Tap the button to call Model
Menu screen.
→ (Menu)
• System
• Linkage
• Model select
Tap the button to call each Menu
screen.
Battery Indicator
• When the low battery, the
alarm will beep. Land your
aircraft immediately.
Condition name
• The condition name
that is currently used
is displayed here.
WARNING
Be sure to conrm the model name before ying your aircraft.
Check the battery voltage as often as possible and try to charge the battery earlier.
If the battery alarm makes a sound, land your aircraft immediately.
*You can adjust the LCD contrast by the display setting in the system menu.

FUTABA T16IZ Specifications

General

Channels	16
Frequency	2.4GHz
Telemetry	Yes
Voice Alerts	Yes
SD Card Slot	Yes
USB Port	Yes
Trainer Port	Yes
Modulation	T-FHSS, S-FHSS
Display	4.3-inch color touchscreen
Battery	7.4V 2000mAh
Model Memory	30 models