102
<Model Menu (Common Functions)>
MODEL MENU (COMMON FUNCTIONS)
System Menu Linkage Menu Model Menu Return
Model 1 Condition 1
85%
Model Menu
Condition Select AFR ( D/R ) Prog. Mixes
Flap Setting AIL to CamberFLP
Airbrake to ELE ELE to Camber
RUD to AIL
AIL Differential
Servo Monitor
AIL to RUD
CamberFLP to ELE
Camber Mix
1/2
AIL to Brake FLP
RUD to ELE
Snap Roll
This section describes the AFR, program mixing,
and other functions common to all model types.
Before setting the model data, use the Model
Type function of the Linkage Menu to select the
model type matched to the fuselage. When another
model type is selected thereafter, the AFR, program
mixing, and other setting data are reset.
The functions in the Model Menu can be set for
each flight condition. When you want to use the
system by switching the settings for each condition
by switch, stick position, etc., use the Condition
Select function to add flight conditions. (Up to 8
conditions can be used)
Note: The T18MZ is designed so that the airplane
and glider (including EP glider) model types are
compatible with fuselages of similar type wings.
This section outlines the relationship between the
functions common to airplanes and gliders, except
some dedicated functions, and model type.
The setting items depend on the number of servos
and other differences according to the wing type
used, but reread them. The setup screens in the
instruction manual are typical examples.
●Return to Home screen
● Touch the Model Menu button of the Home screen to call the
Model Menu.
● When the button of the function you want to set is touched, a
setup screen appears.
(Model Menu screen example)
*The Model Menu screen depends on the model type. This screen is for model type Airplane Wing Type 4AIL+4FLP.
●To next page
Model Menu functions (Common) list
●Servo Monitor
Servo test and servo position display (For a
description of its functions, see the Linkage Menu
section.)
●Condition Select
Flight conditions addition, deletion, copy,
condition renaming, and condition delay can be set.
●AFR (D/R)
Sets the rudder angle and curve of all the
operation functions. A D/R curve which can be
switched with a switch, etc. can also be added.
●Prog. Mixes
Program mixing which can be freely customized.
Up to 10 mixes can be used for each condition.
●Fuel Mixture
Mixing used in needle adjustment of engines
which use a fuel mixture control carburetor.
[Airplane, helicopter]
To Next Page
Loading...
