FUTABA T18MZ FASSTest-2.4GHz - LED Monitor; Switch Reallocation (SA-SH)

15
<Before Use>
•Rotating antenna
The antenna can be rotated 90 degrees and angled
90 degrees. Forcing the antenna further than this
can damage it. The antenna is not removable.
90°
90°
•Angle adjustment of the antenna
The antenna rotation and angle can be adjusted.
The antenna features weak radio waves in the
forward direction and strong radio waves in the
sideways directions. Adjust the antenna angle to
match your ying style.
LED monitor
The status of the transmitter is displayed by
changing the “MONITOR” section LED.
(LED Display)
▅FASSTest mode
→
Light Blue light
▅FASST mode
→
Green light
▅S-FHSS mode
→
yellow-green light
▅RF-OFF
→
Violet light
▅Starting
→
Red light
▅Trainer Student
→
Blue light
Switch reallocation
You can reallocate the toggle switches on the
shoulders of the transmitter, as you like.
(Default settings)
• SA : 3 positions; Alternate; Short lever
• SB : 3 positions; Alternate; Long lever
• SC : 3 positions; Alternate; Long lever
• SD : 3 positions; Alternate; Short lever
• SE : 3 positions; Alternate; Short lever
• SF : 2 positions; Alternate; Long lever
• SG : 2 positions; Alternate; Short lever
• SH : 2 positions; Momentary; Long lever
*You can choose the Switch and the On/Off position in the
Switch Selection menu of your mix.
•When you change switches:
To relocate switches;
1. Make sure your transmitter is off, and use
the attached 2.5mm hexagonal wrench
(included) to turn the screw counter-
clockwise on the switch block and detach
the block. Remove the screw holding the
switch block. Pull up on the switch block to
remove it.
2. Disconnect the connectors of switches you
want to change.
Low power
High power High power