144
<Model Menu (Helicopter Functions)>
Acceleration Mixing
An acceleration function can be set. This is used
to adjust the pitch and throttle settings when the
mixture is either too rich or too lean, which can be
caused by sudden operation of the throttle stick.
● Return to Model Menu
● Touch the [Acceleration] button in the Model
Menu to call the setup screen shown below.
● Pitch setting
●Operation point setting
● Throttle setting
Setting method
● Acceleration can be set at both setting at
acceleration (high) and setting at deceleration
(low).
(The operation point is displayed on a graph.)
● Acceleration rate setting (Rate)
● The return time after operation (Dumping) can be
set.
● The operation point at acceleration and
deceleration can be set. When an operation point
is exceeded, acceleration is performed.
Note: When using the Acceleration funtion, since the pitch
stroke is large, make your settings so there is no binding
of your linkage.
To Next Page
Loading...
