FUTABA T18MZ FASSTest-2.4GHz - Servo(Option); Toolbox

27
<Before Use>
Toolbox
●Tool for removing
decoration nuts
●Hex. Wrench (1.5mm and 2.5mm)
●Rubber Cap
A special toolbox is included with your T18MZ.
This allows you to make off of the mechanical
adjustments that may be needed.
Hexagonal wrench (1.5mm and 2.5mm)
These wrenches are for adjustment of sticks,
replacement of the switches.
Tool for removing switch nuts.
This is used when changing or replacing
switches.
Stylus pen
A rubber cap is attached to the stylus pen/
toolbox. You may use this stylus with rubber cap
when operating the touch panel. The stylus allows
more precise operation than ngers without fear of
damaging the panels surface.
●You may use this tool
as a stylus pen.
Servo(Option)
・
Toolbox
Servo(Option)
Purchase servos appropriate for their intended use.
*Analog servos may not be used when operating in the
FASSTest 12CH mode.
When operating in the FASSTest12Ch mode use digital servos,
this includes all brushless and S.Bus servos.